Honda NSX-T 1998 Manual page 1072

Main Menu
Doors
Glass Adjustment (cont'd)
8. Adjust the Clearance "H" as follows:
a. Loosen the bolts and nuts securing the front sash,
rear sash and stopper plates, then move the front
sash all the way forward and move the rear sash
all the way backward.
NOTE: Hold the adjusting bolts with a hex
wrench when loosening the locknuts.
b. Loosen the bolts securing the regulator assem-
bly, and move the regulator assembly fore or aft
to align the glass with the body at the front and
center pillars.
Table of Contents
"H" (See page 20-15)
c. Loosen the nuts securing the rear glass guide, and
adjust the glass fore and aft by moving the rear
glass guide.
NOTE: Hold the adjusting bolts with a hex
wrench when loosening the locknuts.
d. Repeat steps b and c until clearance "H" is
within the specified limits, then secure the regu-
lator and glass guide. Press the stopper plates
against the glass stoppers, then secure the stop-
per plates.
NOTE: Check that the stopper plates contact the
glass stoppers evenly.