Honda NSX-T 1998 Manual page 1066

Main Menu
Doors
Disassembly (cont'd)
14. Remove the locknuts, then remove the rear glass
guide.
NOTE:
• Hold the adjusting bolt with a hex wrench when
removing the locknuts.
• Scribe a line around the locknuts to show the
original adjustment.
REAR GLASS GUIDE
CORROSION RESISTANT BOLT/NUT
15. Before removing the latch assembly and lock
cylinder, raise the glass fully by connecting a 12 V
battery to the power window motor (see
section 23).
16. Remove the retainer by sliding it forward. Pry the
cylinder rod out its joint using a flat tip screwdriver,
then carefully remove the lock cylinder.
NOTE: Take care not to bend the cylinder rod.
LOCK CYLINDER
CYLINDER ROD
CYLINDER ROD
Table of Contents
LOCKNUT
ADJUSTING BOLT
LOCKNUTS
RETAINER
GLASS
1 7. Disconnect the lock rod and remove the lock crank.
Remove the handle cable and clips.
Remove the mounting screws, then remove the
latch assembly through the hole in the door.
NOTE: Take care not to bend the lock rod and han-
dle cable.
LATCH ASSEMBLY
MOUNTING SCREW
LOCK ROD
18. Lower the glass and remove the mounting nuts,
then remove the stopper plates.
NOTE:
• Lower the glass by connecting a 1 2 V battery to
the power window motor (see
• Scribe a line around the mounting nuts to show
the original adjustment.
STOPPER PLATES
MOUNTING NUT
HANDLE CABLE
CLIPS
LOCK CRANK
section 23).
MOUNTING
NUT