Table of Contents
Advertisement
Main Menu
Illustrated Index
NOTE:
• This transmission uses no gaskets between the major housings; use liquid gasket (P/N 08718-0001).
If 20 minutes have passed after applying liquid gasket, reapply it and assemble the housings and allow it to cure at
least 30 minutes after assembly before filling the transmission with oil.
•
Always clean the
CLUTCH RELEASE HANGER
RELEASE HANGER SPRING
RELEASE BEARING GUIDE
40 x 68 x 12.5 mm OIL SEAL
Replace.
14 x 20 mm DOWEL PIN
CLUTCH HOUSING
VEHICLE SPEED SENSOR (VSS)
DIFFERENTIAL SPEED SENSOR
O-RING
Replace.
RELEASE BEARING GUIDE COVER
REVERSE SHIFT FORK ASSEMBLY
Disassembly/Reassembly, page
13-22
REVERSE IDLE GEAR SHAFT
ASSEMBLY
Disassembly/Reassembly, page
13-21
Table of Contents
whenever the transmission housing is disassembled.
OIL GUIDE RING
90 mm WASHER
BEARING OUTER RACE
DIFFERENTIAL ASSEMBLY
section 15
BEARING RETAINING PLATE
COUNTERSHAFT ASSEMBLY
Index, page
MAINSHAFT ASSEMBLY
Index, page
75 mm SPRING WASHER
32 x 46 x 7 mm OIL SEAL
Replace.
13-35
13-29
TRANSMISSION MAGNET
SHIFT FORK ASSEMBLY
13-28
OIL PUMP ASSEMBLY
13-42
CHANGE HOLDER ASSEMBLY
Disassembly/Reassembly, page
13-25
UPPER COVER
SELECT LEVER ASSEMBLY
13-23
13-48
REVERSE SHIFT ARM
14 x 20 mm DOWEL PIN
10 x 20 mm DOWEL PIN
Advertisement
Chapters
Table of Contents
