Honda NSX-T 1998 Manual page 964

Main Menu
Hub Replacement
NOTE:
• Use only genuine Honda wheel weights for aluminum wheels. Non-genuine wheel weights may corrode and damage
the aluminum wheels.
• On the aluminum wheels, remove the center cap from inside of the wheel after removing the wheel.
• Before installing the brake disc, clean the mating surface of the rear hub and inside of the brake disc.
• Before installing the wheel, clean the mating surfaces of the brake disc and inside of the wheel.
Corrosion resistant bolt/nut
HUB BEARING
ASSEMBLY
Inspect for faulty
movement and wear.
Replacement, page 18-33
REAR HUB UNIT
Check for damage and
cracks.
Replacement, page 18-33
BRAKE DISC
Check for wear and
rust.
Inspection,
Section
Table of Contents
FLANGE BOLT
10 x 1.25 mm
64 N-m (6.5 kgf-m,
47 Ibf-ft)
19.
FLAT HEAD SCREW
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7 Ibf-ft)
KNUCKLE
SPLASH GUARD
WHEEL NUT
12 x 1.5 mm
108 N-m (11 kgf-m,
80 Ibf-ft)
CENTER CAP