Honda NSX-T 1998 Manual page 862

Main Menu
Bearing
Replacement
NOTE:
• The bearing and outer race should be replaced as a
set.
• Inspect and adjust the bearing preload whenever the
bearing is replaced.
1. Remove the tapered roller bearings using the bear-
ing pullers.
Table of Contents
BEARING PULLER
(Commercially
available)
TAPERED ROLLER
BEARING
BEARING PULLER
(Commercially
available)
TAPERED ROLLER
BEARING
2. Install the tapered roller bearings using a special
tool and a press as shown. Press the tapered roller
bearings squarely until they bottom against the
case.
Transmission Housing Side:
PRESS
STEEL PLATE
TAPERED ROLLER
BEARING
Clutch Housing Side:
PRESS
STEEL PLATE
TAPERED ROLLER
BEARING
ATTACHMENT,
45 x 55 mm I.D.
07MAD - PR90100
ATTACHMENT,
45 x 55 mm I.D.
07MAD - PR90100