Honda NSX-T 1998 Manual page 885

Main Menu
Intermediate Shaft
Replacement
1. Drain the fluid from the transmission
(see section 13 M/T or
2. Remove the right driveshaft assembly (see page 16-3).
3. Remove the heat shield.
FLANGE BOLT
6 x 1.0 mm
9.8 N m
(1.0 kgf-m, 7.2 Ibf-ft)
4. Make a mark on the support base and the bearing
support during disassembly to ensure proper posi-
tioning during reassembly.
Corrosion resistant bolt/nut
SUPPORT BASE
Mark
Table of Contents
section 14 A/T).
Corrosion resistant bolt/nut
HEAT SHIELD
FLANGE BOLT
8 x 1.25 mm
22 N-m
(2.2 kgf-m, 16 Ibf ft)
Mark
BEARING SUPPORT
ASSEMBLY
Lightly tap the support base using
a plastic hammer.
5. The bearing support assembly is a light press fit in
the support base. To remove the bearing support
assembly, remove the 8 x 1.25 mm flange bolts with
the support base still attached to the engine block.
Tap the flanged section of the bearing support with
a plastic hammer toward the wheel side, then
remove the bearing support assembly from the sup-
port base.
CAUTION: To prevent damage to the differential
oil seal, hold the intermediate shaft horizontal until
it is clear of the differential.
6. Remove the support base from the engine block.
FLANGE BOLT
8 x 1.25 mm
22 N-m
(2.2 kgf-m, 16 Ibf-ft)
SUPPORT BASE
7. Install in the reverse order of removal. Align the
marks, and install by tapping on the bearing sup-
port assembly shaft end.