Table of Contents
Advertisement
Main Menu
Stall Speed
Test
CAUTION:
• To prevent transmission damage, do not test stall speed for more than 10 seconds at a time.
• Do not move the shift lever while raising the engine speed.
• Be sure to remove the pressure gauge before testing stall speed.
1.
Engage the parking brake and block all four wheels.
2.
Connect a tachometer to the engine (or use the PGM Tester), then start the engine.
3.
Make sure the A/C switch is OFF.
4.
After the engine has warmed up to normal operating temperature (the cooling fan comes on), shift into
5.
Fully depress the brake pedal and accelerator for 6 to 8 seconds, and note engine speed.
6.
Allow 2 minutes for cooling, then repeat same test in
NOTE:
• Stall speed tests should be used for diagnostic purposes only.
• Stall speed should be the same in
Stall Speed RPM: Specification: 2,100 rpm
Service Limit: 1,950 - 2,250 rpm
Table of Contents
positions.
positions.
position.
Advertisement
Chapters
Table of Contents
