Honda NSX-T 1998 Manual page 883

Main Menu
Driveshafts
Reassembly
1 3. Fit the rollers to the spider with their high shoulders
facing outward.
CAUTION.
• Reinstall the rollers in their original positions on
the spider.
• Hold the driveshaft assembly with the rollers up
to prevent them from falling off.
14. Pack the joint with joint grease included in the new
joint hoot set.
Grease Quantity: 120 - 130 g (4.2-4.6 oz)
Table of Contents
SPIDER
Marks
ROLLER
High shoulder faces
toward outside
15. Fit the inboard joint onto the driveshaft.
CAUTION: Reinstall the inboard joint in the original
position on the rollers.
INBOARD JOINT
16. Adjust the length of the driveshafts to the figure
below, then adjust the boots to halfway between
full compression and extension. Bleed the air from
the boot, and check that the engs of the boot seat
are in the grooves of the joint and driveshaft.
Left Driveshaft
M/T: 501.0-506.0 mm (19.72-19.92 in)
A/T: 507.0-512.0 mm (19.96-20.16 in)
Right Driveshaft
M/T and A/T: 542.0 - 547.0 mm (21.34-21.54 in)
Align the roller holders with the
inboard joint as shown
below.
HOLDER
195.0 mm (7.68 in)
195.0 mm (7.68 in)