Honda NSX-T 1998 Manual page 1164

Main Menu
5. Remove the screws, then remove the rear pillar
retainer.
REAR PILLAR
RETAINER
6. Scrape the old sealant from the body bonding sur-
face with a putty knife.
NOTE: Do not scrape down to the painted surfaces
of the body.
7. Clean the body bonding surface with a sponge damp-
ened in alcohol.
NOTE: After cleaning, keep oil, grease and water
from getting on the surface.
8. If the old rear pillar retainer is to be reinstalled, use
a putty knife to scrape off all of the old sealant, then
clean the rear pillar retainer surface with alcohol
where new sealant is to be applied.
Table of Contents
Screw locations, 2
9. Install the rear pillar retainer.
NOTE:
• Be careful not to touch the rear pillar retainer
where sealant will be applied.
• First tighten the screw at top of the rear pillar
retainer.
REAR PILLAR
RETAINER
10. Apply new sealant to the body and rear pillar retainer
on each side as shown.
: Sealant locations
(Cemedine P/N 08712 - 0004, or equivalent)
RETAINER
Screw locations, 2
Tighten first.
SEALANT
REAR PILLAR
RETAINER