Table of Contents
Advertisement
Main Menu
Ignition System
Idle Speed Inspection
1.
Start the engine. Hold the engine at 3,000 rpm with
no load (A/T in
until the radiator fan comes on, then let it idle.
2.
Connect a tachometer to the test tachometer con-
nector.
JUMP START
TERMINAL
3.
Check the idle speed with all electrical systems
turned OFF.
Idle Speed (rpm):
4.
Adjust the idle speed if necessary (see
Table of Contents
or
position, M/T in neutral)
TEST
TACHOMETER
CONNECTOR
TEST
TACHOMETER
CONNECTOR
section
Ignition Control Module (ICM)
Replacement
1.
Disconnect the 8P and 6P connectors from the igni-
tion control module (ICM).
2.
Remove the two mounting bolts, and slide the ICM
out toward the front side. Be careful not to damage
the vacuum hoses when removing the ICM.
8P CONNECTOR
11).
MOUNTING BOLTS
12 N-m
(1.2 kgf-m, 9 Ibf-ft)
G103
SERVICE LOOP
6P CONNECTOR
Advertisement
Chapters
Table of Contents
