Honda NSX-T 1998 Manual page 886

Main Menu
Disassembly
CAUTION: The bearing support and support base are
made of aluminum. Be careful not to damage them
when servicing.
1. Remove the intermediate shaft outer seal from the
bearing support.
BEARING SUPPORT
2. Remove the external circlip and internal circlip.
EXTERNAL CIRCLIP
Table of Contents
OUTER SEAL
Replace.
INTERNAL CIRCLIP
3. Press the intermediate shaft out of the shaft bearing
using the special tool and a press.
INTERMEDIATE
SHAFT
4. Remove the intermediate shaft inner seal from the
bearing support.
HUB DIS/ASSEMBLY
BASE
Press
07GAF - SD40700
INNER SEAL
Replace.