Honda NSX-T 1998 Manual page 1063

Main Menu
Disassembly
NOTE: Lower the glass fully.
1. Carefully pry out the trim plate with a flat tip
screwdriver as shown.
CAUTION: To prevent damage to the trim plate,
wrap the end of the screwdriver with a shop towel.
TRIM PLATE
SHOP TOWEL
FLAT TIP SCREWDRIVER
2. Remove the trim plate by pulling it backward, and
remove the mounting screws.
MOUNTING SCREWS
Remove the mounting screws while
pulling the handle.
INNER HANDLE
TRIM PLATE
Table of Contents
HANDLE
3. Disconnect the connector and handle cable, then
remove the inner handle by pulling it forward.
NOTE: Take care not to bend the handle cable.
4. Carefully remove the front and rear sash covers.
NOTE: Take care not to scratch the sash covers.
Take care not to
break here.
CLIP
HANDLE CABLE
INNER
HANDLE
CONNECTOR
FRONT SASH COVER
SASH COVER
REAR SASH COVER