Honda NSX-T 1998 Manual page 709

Main Menu Table of Contents
20. Install the right driveshaft onto the intermediate shaft.
21. Install the lower control arm to the side beam (see section 18). Align the reference marks on the adjusting bolt, adjust-
ing cam and lower control arm.
22. Install the damper fork bolt (see section 18).
23. Install the toe control arm to the side beam (see section 18). Make sure that the arrow marks on the toe control arm
are aligned.
24. Install the wheel sensor wire clamp and parking brake cable holder.
25. Install the rear beam rod.
26. Install the parking brake cable holders on the rear beam rod.