Honda NSX-T 1998 Manual page 700

Main Menu
Mainshaft Thrust Shim
Adjustment
1. Remove the thrust shim and oil guide plate from the
transmission housing.
2. Install the mainshaft in the transmission housing.
Do not install the clutch housing side ball bearing.
3. Measure
transmission housing and mainshaft. Use a straight
edge and feeler gauge, and measure at three loca-
tions and average the readings.
4. Set the mainshaft ball bearing in the clutch hous-
ing, and measure distance
faces of the clutch housing and the bearing in-
ner race. Use a straight edge and feeler gauge, and
measure at three locations and average the read-
ings. Do not install the spring washer.
Table of Contents
between the end of the
between the sur-
5. Select the proper thrust shim on the basis of the
following calculations. Do not use more than two
thrust shims.