Table of Contents
Advertisement
Main Menu
Mirror
Removal
NOTE: Raise the glass fully.
1.
Remove the door panel, and carefully remove the
plastic cover (see pages 20-7, 20-8).
2.
Disconnect the connector.
3.
Remove the mounting nuts from the hole in the
door while holding the mirror.
NOTE: Do not drop the mounting nuts inside the
door.
CONNECTOR
(Mirror side)
4.
Installation is the reverse of the removal procedure.
5.
Check for water leaks.
NOTE: Do not use high-pressure water.
CORROSION RESISTANT NUT
Table of Contents
MIRROR
Mirror Holder Replacement
1.
Insert a Phillips screwdriver in the door mirror
through the service hole, then loosen the actuator
retaining screw.
MIRROR
2.
Pull the mirror holder out of the mirror housing.
Disconnect the
connector.
MIRROR HOUSING
3.
Remove the actuator (see
4.
Installation is the reverse of the removal procedure.
ACTUATOR
RETAINING SCREW
ACTUATOR
MIRROR HOLDER
section
23).
Advertisement
Chapters
Table of Contents
