Honda NSX-T 1998 Manual page 439

Main Menu
Cylinder Heads
Illustrated Index (cont'd)
CAUTION: To avoid damage, wait until the engine coolant temperature drops below 100°F (38°C) before removing the cylin-
der head.
NOTE: Use new O-rings and gaskets when reassembling.
Prior to reassembling, clean all the parts in solvent, dry them, and apply lubricant to any contact parts.
REAR VARIABLE VALVE TIMING
AND VALVE LIFT ELECTRONIC CONTROL
SYSTEM (VTEC) SOLENOID VALVE
Troubleshooting, page 6-3
FILTER
Replace.
Table of Contents
EXHAUST GAS
RECIRCULATION (EGR) VALVE
ROCKER SHAFT
OIL CONTROL
ORIFICE
Remove with 5 mm
bolt and clean.
ENGINE COOLANT
TEMPERATURE (ECT) SENSOR
FRONT VTEC SOLENOID VALVE
Troubleshooting, page
SEALING BOLTS
49 N-m (5.0 kgf-m,
36 Ibf-ft)
OIL PRESSURE
GAUGE SENDING
UNIT
RADIATOR FAN CONTROL SENSOR
27 N-m (2.8 kgf-m, 20 Ibf-ft)
ROCKER ARM ASSEMBLY
(PRIMARY, MID, SECONDARY)
Inspection, pages 6-33,
6-3
(section 23)
DOWEL PIN
O-RING
Replace.
6-34