Honda NSX-T 1998 Manual page 1157

Main Menu
5. Remove the front pillar seal.
6. Remove the screws, then remove the front pillar
retainer.
NOTE: If necessary, remove the glass guide clip
from the front pillar retainer.
Screw locations, 7
FRONT PILLAR
RETAINER
Table of Contents
FRONT PILLAR
SEAL
GLASS GUIDE
CLIP
7. Scrape the old sealant from the body bonding sur-
face with a putty knife.
NOTE: Do not scrape down to the painted surfaces
of the body.
8. Clean the body bonding surface with a sponge
dampened in alcohol.
NOTE: After cleaning, keep oil, grease and water
from getting on the surface.
9. If the old front pillar retainer is to be reinstalled, use
a putty knife to scrape off all of the old sealant and
the EPT sealer as shown, then clean the front pillar
retainer surface with alcohol where new sealant and
EPT sealer are to be applied.
FRONT PILLAR
RETAINER
10. Glue the new EPT sealer to top edge of the front pil-
lar retainer as shown.
EPT sealer thickness: 5 mm (0.2 in)
NEW
10 mm (0.39 in)
EPT
SEALER
FRONT PILLAR
RETAINER
Scrape off.
EPT SEALER
FRONT PILLAR
RETAINER
NEW
EPT
SEALER