Table of Contents
Advertisement
Main Menu
17. Install new boot bands on the boots, then bend both
sets of locking tabs.
1 8. Lightly tap on the doubled-over portions to reduce
their height.
LOCKING TABS
NOTE: Install the outboard joint in the knuckle
before installing the driveshaft into the differential
or intermediate shaft. Loosely install the spindle
nut this time.
Table of Contents
19. Install the new set rings in the driveshaft groove
and intermediate shaft groove.
20. Apply a light film of grease around the set ring groove
on the inboard joint, then install a new set ring and
center it on the joint. The grease will keep the set
ring centered, making the installation of the joint
easier.
21. Install the inboard end of the driveshaft into dif-
ferential or intermediate shaft.
CAUTION:
• Always use a new set ring whenever the drive-
shaft is being installed.
• Make sure the left driveshaft locks in the differ-
ential side gear groove, and the inboard joint
subaxle bottoms in the differential.
• Insert the right driveshaft inboard joint subaxle
into the intermediate shaft until the intermedi-
ate shaft set ring locks in the groove in the right
driveshaft.
Apply light film of
grease before installing.
INBOARD JOINT
SET RING
Left Driveshaft
inboard end
SET RING GROOVE
Right Driveshaft
inboard end
(Intermediate shaft side)
Advertisement
Chapters
Table of Contents
