Honda NSX-T 1998 Manual page 415

Main Menu
40. Remove the right wheel sensor wire clamps and
stabilizer link.
41. Disconnect the front secondary heated oxygen sensor
connector, then remove the front exhaust pipe A,
front three way catalytic converter (TWC) and front
joint pipe assembly (A/T).
42. Separate the rear joint pipe from the muffler (A/T).
Table of Contents
43. Remove the muffler (M/T).
44. Position the special tool under the car. Lower the car
just above the fixture. With the help of an assistant,
attach the fixture to the subframe with two 12 mm
nuts and two 10 mm bolts.
45. Adjust the pads on the fixture to support the oil pan
and transmission housing.
46. Lower the car so the fixture is resting on its casters
(or appropriate platform).
ENGINE REMOVAL/
INSTALLATION
FIXTURE
07MAK - PR7020A