Table of Contents
Advertisement
Main Menu
Inspection
NOTE:
• Check the telescopic mechanism, tilt mechanism, and steering joint bearings or steering shaft for movement and damage.
Replace as an assembly if damaged or faulty.
• If either the steering column assembly or TCS sensor is removed, select the appropriate shim and adjust the distance
between the steering shaft and TCS sensor. Refer to
Attach a spring scale to the knob of the telescopic lever.
Measure the force required to move the lever.
Preload: 70 - 90 N (7 - 9 kgf, 15 - 20 Ibf)
Table of Contents
Section 19
for shim selection.
If the force measured is not within the specification,
loosen the locknut, then turn the telescopic adjusting
bolt until the correct force can be obtained.
Advertisement
Chapters
Table of Contents
