Honda NSX-T 1998 Manual page 865

Main Menu
Clutch Disc, Clutch Plate
Replacement
NOTE: The clutch discs and clutch plates should be
replaced as a set.
1. Remove the clutch discs and clutch plates (see
page 15-20).
2. Soak the clutch discs for five minutes in transmis-
sion oil.
3. Install the clutch discs, clutch plates, and a stan-
dard shim.
NOTE: Position the 11 2 mm thrust shim with the
thickness size mark facing away from the clutch
discs.
112 mm THRUST SHIM
Table of Contents
FINAL
DRIVEN
GEAR
4. Install the differential housing. Tighten the bolts
evenly in several steps, then torque them in a criss-
cross pattern.
Torque: 39 N-m (4.0 kgf-m, 29 Ibf-ft)
5. Make sure the preset torque is within the standard
(see page 15-18).
6. If preset torque is beyond the standard, replace the
112 mm thrust shim as necessary.
112 mm THRUST SHIM