Table of Contents
Advertisement
Main Menu
Steering Column
Installation
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS
(section
24) before performing repairs or ser-
vice.
1.
Slip the lower end of the steering joint onto the pin-
ion shaft.
2.
Reposition the column assembly on the hanger
bracket, and loosely tighten with 8 mm flange nuts.
3.
Tighten to the steering joint bolts.
NOTE:
• Be sure that the lower bolt is securely in the
groove in the steering gearbox pinion shaft.
• Be sure the pinion shaft and the steering column
shaft are aligned; the joint should slip on freely.
If not reposition the steering rack to correct the
misalignment.
Table of Contents
4.
Install the column holder with the 8 mm bolts.
5.
Tighten the 8 mm flange nuts to the specified
torque.
6.
Install the steering joint cover with the clamps and
clips.
Advertisement
Chapters
Table of Contents
