Table of Contents
Advertisement
Main Menu
Power Door Locks
Control Unit Input Test
1.
Remove the glove box, then disconnect the 20P connector from the control unit.
2.
Inspect the connector terminals to be sure they are all making good contact.
• If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector.
— If any test indicates a problem, find and correct the cause, then recheck the system.
— If all the input tests prove OK, the control unit must be faulty; replace it.
Table of Contents
Advertisement
Chapters
Table of Contents
