Table of Contents
Advertisement
Ignition Lock Cylinder Case Replacement
Callout
Preliminary Procedure
Remove the multifunction turn signal switch housing. Refer to "Multifunction Turn Signal Switch Housing
Replacement: ".
Ignition Lock Cylinder Case Bolt
CAUTION
!
Refer to "Fastener Notice: ".
1
Procedure
1. Use a small chisel and hammer to back out the ignition lock cylinder case bolt counterclockwise
and remove it.
2. When installing a new ignition lock cylinder case bolt continue to tighten it until the head shears off.
2
Ignition Lock Cylinder Case Strap
Ignition Lock Cylinder Case
Procedure
Disconnect any electrical connectors as needed.
3
Tip: The ignition lock cylinder must be turned to the run position in order to remove and/or install the
ignition lock cylinder case.
Steering Wheel and Column:
Component Name
6B-16
Advertisement
Table of Contents
Troubleshooting
