Suzuki XL7 2007 Service Manual page 1806

6C-24 Power Assisted Steering System:
5. Install the transaxle mount and transaxle mount bolts
(1).
Tightening torque
Tighten to 50 N⋅m (37 lb ft).
6. Install the transaxle mount bolt (1).
Tightening torque
Tighten to 110 N⋅m (81 lb ft).
7. Clean any excess fluid from the vehicle and remove
the drain pans.
8. Install the intermediate steering shaft lower bolt.
Refer to "Intermediate Steering Shaft Replacement:
".
9. Connect the rack and pinion outer tie rods to the
steering knuckles. Refer to "Rack and Pinion Outer
Tie Rod End Replacement".
10. Fill and bleed the power steering system. Refer to
"Power Steering System Bleeding".
11. Adjust the front toe. Refer to "Front Toe Adjustment:
".
Steering Gear Boot Replacement - Off
Vehicle
Special tool
J 22610 Keystone Clamp Pliers
Removal Procedure
1. Remove the rack and pinion outer tie rods. Refer to
"Rack and Pinion Outer Tie Rod End Replacement".
2. Remove the power steering gear. Refer to "Steering
Gear Replacement".
3. Completely remove the steering linkage inner tie rod
nuts.
4. Remove the steering gear clamp (1) from the
steering gear boot.
5. Cut, remove, and discard the steering gear clamp
(1).