Table of Contents
Advertisement
6C-18 Power Assisted Steering System:
Installation Procedure
1. Position the power steering cooler pipe to the
vehicle.
2. Reconnect all power steering cooler pipe routing
brackets to the vehicle.
CAUTION
!
Refer to "Fastener Notice: ".
3. Connect the power steering cooler pipe fitting (1) to
the power steering gear.
Tightening torque
Tighten to 25 N⋅m(18 lb ft).
4. Compress the power steering cooler pipe clamp (1)
and connect the power steering cooler pipe (2) to the
remote power steering fluid reservoir.
5. Clean any excess fluid from the vehicle and remove
the drain pans.
6. Install the left side engine splash shield. Refer to
"Engine Splash Shield Replacement - Left Side: ".
7. Install the front tire/wheel assemblies. Refer to "Tire
and Wheel Removal and Installation: ".
8. Install the air cleaner outlet duct. Refer to "Air
Cleaner Outlet Duct Replacement: ".
9. Install the fuel injector sight shield. Refer to "Fuel
Injector Sight Shield Replacement: ".
10. Fill and bleed the power steering system. Refer to
"Power Steering System Bleeding".
Power Steering Fluid Reservoir Outlet Hose
Replacement
Removal Procedure
1. Remove the fuel injector sight shield. Refer to "Fuel
Injector Sight Shield Replacement: ".
2. Remove as much power steering fluid from the
remote power steering fluid reservoir as possible.
3. Remove the right side engine splash shield. Refer to
"Engine Splash Shield Replacement - Right Side: ".
4. Place drain pans under the vehicle as needed.
5. Compress the power steering reservoir outlet hose
clamp (1) and disconnect the power steering
reservoir outlet hose (2) from the remote power
steering fluid reservoir.
Advertisement
Table of Contents
Troubleshooting
