b. Remove the server from the rack.
6.
Remove the access panel.
7.
Remove the serial port blank.
8.
Connect the serial cable, and then secure the cable with screws.
9.
Remove the backing from the double-sided tape and press down where
indicated.
10. Install the access panel (Install the access panel).
11. Install the server in the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14.
Power up the server (Power up the server).
Installing the Chassis Intrusion Detection switch option
Prerequisites
Before installing this option, be sure you have the following:
•
The components included with the hardware option kit
•
•
T-15 Torx screwdriver
Procedure
Power down the server.
1.
Remove all power:
2.
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
Do one of the following:
3.
a. Extend the server from the rack.
Hitachi Advanced Server HA810 G2 User Guide
103
Need help?
Do you have a question about the Advanced Server HA810 G2 and is the answer not in the manual?