30. If installed, close the cable management arm.
31. Power up the server.
32. Install the SAS, SATA, or U.3 NVMe drives.
33. Install the front bezel.
The installation is complete.
Optical drive option
The server supports a slim-type SATA optical drive.
Installing the optical drive in the LFF drive chassis
Prerequisites
•
Before you perform this procedure, make sure that you have the following items available:
◦
T-10 Torx screwdriver
◦
Phillips No. 1 screwdriver
◦
Spudger or any small prying tool
About this task
CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other
static-sensitive devices. To prevent damage, observe antistatic precautions.
Procedure
1.
If installed, remove the front bezel.
2.
Power down the server.
3.
If installed, open the cable management arm.
Hardware options installation
101