Table of Contents
Advertisement
8. Place the server on a flat, level work surface.
Remove the access panel
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components
to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any installation,
removal, or replacement procedure. Improper grounding can cause electrostatic discharge.
CAUTION: To maintain proper system cooling, do not operate the server for long period with the access panel open or
removed. Operating the server in this manner results in an improper system airflow. For internal hot-plug component
procedures, complete the procedure within 60 seconds. Failure to do so can cause the system temperature to increase
and trip the safety threshold. When this happens:
•
The health LED flashes amber.
•
The operating system gracefully shuts down.
Procedure
1. Power down the server.
2. If installed, open the cable management arm.
Operations 45
Advertisement
Table of Contents
