Extend The Server From The Rack; Remove The Server From The Rack; Remove The Access Panel - Hitachi Advanced Server HA810 G2 User Manual

Before proceeding, verify that the server is in standby mode by observing that the system power LED is
amber.

Extend the server from the rack

NOTE: If the cable management arm option is installed, you can extend the server without powering down
the server or disconnecting peripheral cables and power cords. These steps are only necessary with the
standard cable management solution.
Procedure
1. Power down the server.
2. Disconnect all peripheral cables and power cords.
3. Loosen the front panel thumbscrews.
4. Extend the server on the rack rails until the server rail-release latches engage.
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before extending a component from the rack.
WARNING: To reduce the risk of personal injury, be careful when pressing the server rail-release
latches and sliding the server into the rack. The sliding rails could pinch your fingers.
5. After the installation or maintenance procedure, slide the server into the rack:
a. Slide the server fully into the rack.
b. Secure the server by tightening the thumbscrews.
6. Connect the peripheral cables and power cords.

Remove the server from the rack

To remove the server from a rack.
Procedure
1. Power down the server.
2. Extend the server from the rack.
3. Disconnect the cabling and remove the server from the rack. For more information, see the documentation
that ships with the rack mounting option.
4. Place the server on a sturdy, level surface.

Remove the access panel

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
Hitachi Advanced Server HA810 G2 User Guide 29