Figure 228. Radius Server Configuration - Samsung WEC8500 Operation Manual

7
WEC8500/configure/security/radius 1# [no] coa
8
WEC8500/configure/security/radius 1# exit
WEC8500/configure/security# exit
9
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Security>  <AAA>  <RADIUS> menu in the sub-menus.
If you click the <Add> button in the RADIUS initial window, you can add a RADIUS server.
The server addition window is shown below.
Figure 228. RADIUS Server Configuration
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Parameter
RETRY_INTERVAL
RETRY_COUNT
FO_RETRY_COUNT
Enable or disable CoA (Change of Authorization) .
Coa option can be set only with Radius servers with IPv4 address.
Exit RADIUS server configuration and security configuration mode.
To check the configuration information, use the 'show security radius-
server summary' command.
Item
INDEX
TYPE
Description
Retransmission interval for a RADIUS message
(unit: seconds, range: 1-60, default value: 2)
Maximum retransmission count of a RADIUS message
(range: 1-20, default value: 10)
Maximum retransmission count of a RADIUS message
before a RADIUS server failover is attempted
Must smaller than the RETRY_COUNT value (range: 1-
10, default value: 3)
Description
ID that distinguishes RADIUS server configurations
Selects the type of the RADIUS server
• Auth: Performs authentication
• Acct: Performs accounting
350