Igmp Snooping - Samsung WEC8500 Operation Manual

IGMP Snooping

Configuration using CLI
Use the 'ip igmp snooping' command to enable or disable Internet Group Management
Protocol (IGMP) Snooping.
•
•
When this command is executed in the Configure mode, the IGMP Snooping of a bridge
is enabled or disabled. If it is executed in the interface mode, the IGMP Snooping of an
interface is enabled or disabled.
Configuring the IGMP Snooping of a bridge:
WEC8500# configure terminal
WEC8500/configure# ip igmp snooping
Configuring the IGMP Snooping of a VLAN interface:
WEC8500# configure terminal
WEC8500/configure# interface vlan1.10
WEC8500/configure/interface vlan1.10# ip igmp snooping
In addition, a specific function of the IGMP Snooping functions of a VLAN interface can
be enabled or disabled as shown in the below command:
[ip igmp snooping fast-leave]
This command enables or disables the Fast-Leave function. (Default: Enable status)
•
•
[ip igmp snooping querier]
This command enables or disables the Querier function. (Default: Enable status)
•
•
[ip igmp snooping report-suppression]
This command enables or disables the Report-suppression function. (Default: Enable
status)
•
•
[ip igmp snooping mroute]
This command enables or disables the Mroute function.
•
•
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
ip igmp snooping
no ip igmp snooping
ip igmp snooping fast-leave
no ip igmp snooping fast-leave
ip igmp snooping querier
no ip igmp snooping querier
ip igmp snooping report-suppression
no ip igmp snooping report-suppression
ip igmp snooping mroute [INTERFACE]
no ip igmp snooping mroute [INTERFACE]
111