Remote Packet Capture - Samsung WEC8500 Operation Manual

Remote Packet Capture

APC can capture a packet exchanged between the wireless terminals on a remote PC in
real-time by using the remote packet capture protocol.
To configure the remote packet capture function, you must go to the pcap mode by
executing the command as follows:
APC# configure terminal
APC/configure# pcap
Configuring the MAC Address of a Wireless Terminal
Configure the MAC address of a wireless terminal whose packets will be captured.
APC/configure/pcap# config-filter
APC/configure/pcap/config-filter# station-mac [MAC_ADDRESS]
APC/configure/pcap/config-filter# enable-station-mac [INDEX]
Configuring AP MAC Address
Configure the MAC address of an AP whose packets will be captured.
APC/configure/pcap# config-filter
APC/configure/pcap/config-filter# ap-mac [MAC_ADDRESS]
APC/configure/pcap/config-filter# enable-ap-mac [INDEX]
Configuring Filtering Mode
Capture target can be specified by configuring the filtering mode
APC/configure/pcap# filtering-mode [FILTERING MODE]
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Parameter
MAC_ADDRESS
INDEX
Parameter
MAC_ADDRESS
INDEX
Parameter
FILTERING MODE
Description
MAC address (11:22:33:44:55:66 format)
Index number of MAC address (range: 1-10)
Description
MAC address (11:22:33:44:55:66 format)
Index number of MAC address (range: 1-10)
Description
Filtering mode
• station-only: Use only the configured station MAC
information.
• ap-only: Use only the configured AP MAC information.
310