Chapter 8 Security - Samsung WEC8500 Operation Manual

Chapter 8
The W-EP wireless LAN system supports the security function, required in a wire/wireless
network environment, such as RADIUS server interoperation function, system user
management, guest connection service, unauthorized AP/terminal detection and simple
blocking function, firewall, access control (ACL), and so on.
In this chapter, how to configure various security functions supported in the system is
described.
RADIUS Server Configuration
The W-EP wireless LAN system provides the security and authentication function by
interoperating with an external RADIUS server. The WEC8050 also provides the internal
RADIUS server function.
External RADIUS Server
The W-EP wireless LAN system provides the security and authentication function by
interoperating with an external RADIUS server. Follow the below procedure to interoperate
with a RADIUS server.
Basic Settings
The basic steps for configuring a RADIUS server are as follows:
Configuration using CLI
WEC8500# configure terminal
WEC8500/configure# security
WEC8500/configure/wlan 1/security# radius 1
WEC8500/configure/security/radius 1#
WEC8500/configure/security/radius 1# serverIp [IP_ADDRESS]
[IPV4 Address]
WEC8500/configure/security/radius 1# no ipv6-enable
WEC8500/configure/security/radius 1# serverIp [IPV4_ADDRESS]
[IPV6 Address]
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Security
Go to configure  security  radius configuration mode of CLI.
1
2
Configure the IP address of a RADIUS server.
Parameter
IPV4_ADDRESS
Description
The IP version 4 address of a RADIUS server
348