Samsung WEC8500 Operation Manual page 170

RETRANSMIT
SSH
CONTROL
BANDWIDTH
TEMPERATURE-ALARM
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Parameter
REPORT-INTERVAL
STATISTICS-TIMER
RETRANSMIT-INTERVAL
MAX-ECHO-
OVERWRITE-TELNET-
TELNET-ENABLE
SSH-ENABLE
OVERWRITE-CONSOLE
CONSOLE-ENABLE
OVERWRITE-DTLS
DTLS-POLICY
OVERWRITE-LED-
LED-CONFIG
OVERWRITE-VLAN
VLAN-SUPPORT
NATIVE-VLANID
OVERWRITE-POE-TYPE
POE-TYPE
OVERWRITE-UPLINK-
UPLINK-QoS
OVERWRITE-
TEMPERATURE-ALARM-
Description
Configures the time interval for transmitting the description
error from AP to the APC (unit: seconds).
Configures the time interval for transmitting the statistical
information provided by the CAPWAP (unit: seconds).
The APC waits for this length of time before retransmitting
an echo request message when there is no response. The
APC sets double the length of echo-interval as the echo
timeout time. If no echo message is received from the AP
for as long as double the length of the echo-interval, the
APC judges that the AP is down (unit: seconds).
The APC waits for this length of time before retransmitting
an echo request message when there is no response. The
APC sets double the length of echo-interval as the echo
timeout time. If no echo message is received from the AP
for as long as double the length of the echo-interval, the
APC judges that the AP is down (unit: seconds).
If overwrite-telnet-ssh is enabled, the telnet and SSH
settings for the AP group are applied to all APs within the
group.
This enables the telnet server and configures telnet port of
the AP.
This enables the SSH server and configures SSH port of
the AP.
If overwrite-console is enabled, the telnet and SSH settings
of the AP group are applied to all APs within the group.
This configures whether to allow console access to the AP.
If overwrite-dtls is enabled, the DTLS settings of the AP
group are applied to all APs within the group.
Configures the DTLS Policy of an AP.
If overwrite-led-control is enabled, the LED settings of the
AP group are applied to all APs within the group.
This configures whether to turn the LED ON/OFF.
If overwrite-vlan is enabled, the VLAN settings of the AP
group are applied to all APs within the group.
This configures whether to enable the native VLAN of the
AP.
This configures the native VLAN value of the AP.
If the overwrite-poe-type is activated, the POE Type
information set in the AP group is applied to all APs in the
group.
Sets the POE Type information below.
802.3at/802.3af/auto
If the overwrite-uplink-bandwidth is activated, the uplink
bandwidth information set in the AP group is applied to all
APs in the group.
Sets the allowed value for AP uplink QoS. It can configure
0~63 as DSCP method.
If the overwrite-temperature-alarm is activated, the
temperature alarm information set in the AP group is applied
to all APs in the group.
If the temperature of the AP exceeds the Temperature-
151