IP Multicast Configuration
IP Multicast Routing Configuration
Configuration using CLI
1
WEC8500# configure terminal
2
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <Multicast> <IP Multicast> menu in the sub-menus.
After selecting Enable/Disable in the IP Multicast window, click the <Apply> button to
apply the configuration.
Figure 68.
IP Multicast Configuration Window
PIM Configuration
As a multicast layer3 transmission protocol, the PIM has two modes, that is Dense mode
and Sparse mode. The WEC8500 supports only PIM Sparse mode and the PIM Sparse
mode can be configured for each interface.
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure# interface ge2
2
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <Multicast> <PIM-SM> menu in the sub-menus. When you click the
<Add> or <Delete> button, you can add or delete PIM-SM configuration.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
Enable or disable the routing function for IP multicast.
o ip multicast-routing: Enable
o no ip multicast-routing: Disable
Go to configure of CLI mode where you want to perform configuration.
Perform PIM configuration.
o ip pim sparse-mode: Enable
o no ip pim sparse-mode: Disable
108