Figure 208. Dcs Settings; Chdc Configuration - Samsung WEC8500 Operation Manual

WEC8500/configure/rrm/80211a/dcs# aware-option station [station count]
WEC8500/configure/rrm/80211a/dcs# aware-option traffic
12
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Radio>  <802.11a/n/ac> or <802.11b/g/n>  <RRM> menu in the sub-menus.
Enable or disable the DCS in the SERVICE field in Dynamic Channel Selection.
Figure 208. DCS Settings

CHDC Configuration

This section describes the setting options of the CHDC function which adjusts the Tx
Power when Coverage Hole occurs.
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure# rrm
2
WEC8500/configure/rrm# 80211a
3
WEC8500/configure/rrm/80211a# chdc
WEC8500/configure/rrm/80211a/chdc# enable
4
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Check the settings using the 'show rrm config-summary' command.
Go to configure  rrm configuration mode of CLI.
Go to the wireless section where you want to change the settings.
Set the CHDC function. Enter the chdc setting mode and enable it Use
the 'no' parameter to disable the mode. The function operates only when
the RRM is enabled.
To use the pre-alarm function, operator can collect the statistics from an
AP.
After entering into the chdc configuration mode, complete configuration
(statsCollectEnable). To disable the configuration, enter the 'no'
parameter. All the functions for pre-alarm are available only when both
297