Samsung WEC8500 Operation Manual page 227

network, the Repeater AP and Root AP are required. The Repeater AP is working as a
wireless terminal and the Root AP connects a Repeater AP to a wireless terminal for
connection to the APC.
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc#
2
3
WEC8500/configure/apc# show wlan detail repeater
[Changing to Root AP]
The procedure of changing a W-EP AP to a Root AP is as follows:
1
WEC8500# configure terminal
2
WEC8500/configure# show ap summary
3
WEC8500/configure# ap ap_1
4
WEC8500/ configure/ap ap_1# profile ap-mode rootAp
5
[Changing to Repeater AP]
The procedure of changing a W-EP AP to a Repeater AP is as follows:
1
WEC8500# configure terminal
2
WEC8500/configure# show ap summary
3
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure  apc configuration mode of CLI.
Configure the authentication mode for repeater service.
o repeater-service PSK: using PSK mode for authentication.
o no repeater-service EAP: using EAP mode for authentication.
Use the 'show wlan detail repeater' command to check the root WLAN
settings.
Go to the configure mode of the CLI.
Check the registered AP list.
Go to AP configuration mode to change to a Root AP.
Configure it to a Root AP.
Restart the configured AP.
Go to the configure mode of the CLI.
Check the registered AP list.
Go to AP configuration mode of an AP that will be changed to a Repeater
208