Wi-Fi Load Balancing - Samsung WEC8500 Operation Manual

Wi-Fi Load Balancing

The load balancing function in the AP Controller is a function of load balancing by
transferring the message that the connections to wireless stations among APs have been
permitted or cannot be permitted based on the set threshold value and then controlling the
number of stations connected to APs.
Activating Load Balancing Function
The setting can be made based on the WLAN and it is possible to check the load
balancing function among APs for stations attempting at association to APs with the
threshold value and the maximum denial count value based on station count.
Configuration using CLI
For the load balancing function, execute the command as follows:
1
APC# configure terminal
APC/configure# wlan 1
APC/configure/wlan 1#
2
WEC8500/configure/wlan 1# load-balancing enable
WLAN (1), Wi-Fi Load Balancing: Enable
WEC8500/configure/wlan 1# no load-balancing enable
WLAN (1), Wi-Fi Load Balancing: Disable
3
WEC8500/configure/wlan 1# load-balancing threshold_station 100
Wi-Fi Load Balancing threshold: 100 stations
4
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Configure a specific WLAN which requires load balancing.
Activate or deactivate the Load Balancing function.
o load-balancing [MODE]
Parameter
Mode
Configure the load balancing station count threshold value.
o load-balancing threshold_station [VALUE]
Parameter
VALUE
Configure the maximum denial count value.
o load-balancing denial_count [VALUE]
Parameter
VALUE
Description
Whether to configure the Load Balancing function
• enable: Setting
• disable: Release (by default)
Description
1-127 (127 by default)
Description
1-10 (2 by default)
338