Chapter 10 System Management - Samsung WEC8500 Operation Manual

Chapter 10
In this chapter, the various functions used by an operator to manage the system and
troubleshooting method are described. In addition, the configurations required for system
operation such as system configuration management, resource management, alarm
management, package management and various checking methods are described.
SNMP Configuration
SNMP Community
To use an external management server or to manage the system through a web server
after initial system installation, you must configure the SNMP community using CLI.
When creating the SNMP community, you can restrict configuration privilege by allocating
the access right such as read-only or read-write and can also restrict an IP to connect.
You can configure maximum 10 SNMP communities.
Configuration using CLI
To add a SNMP community, execute the command as follows:
WEC8500# configure terminal
WEC8500/configure#
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Administrator> and then select the
<SNMP> <APC>  <Community> menu in the sub-menus. When you click the <Add>
button in the Community window, the community creation window is displayed. When you
enter a configuration value and click the <Apply> button, the configuration is applied.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
System Management
1 Go to the configure mode of the CLI.
Use the 'snmp community' command to add a SNMP community.
2
o snmp community [COMMUNITY_NAME] [ACCESS] [IP_VERSION]
[IP_ADDRESS] [NET MAST]
Parameter
COMMUNITY_NAME
ACCESS
IP_VERSION
IP_ADDRESS, NETMAST
To check the created SNMP community, use the 'show snmp community'
3
command.
Description
Name of a community to add
Access privilege (rw/ro)
• rw: read-write privilege
• ro: read-only privilege
IP address version type (v4/v6)
IP address area that can be connected
436