WEC8500/configure/router/ospf 2# area 2 virtual-link 10.10.10.1 retransmit-interval ?
1 - 65535
WEC8500/configure/router/ospf 2# area 2 virtual-link 10.10.10.1 retransmit-interval
Transmit-delay configuration
The default transmit-delay is 1 second. In addition, operator can change it to a value
between 1 second and 65535 seconds.
WEC8500/configure/router/ospf 2# area 2 virtual-link 10.10.10.1 transmit-delay ?
1 - 65535
WEC8500/configure/router/ospf 2# area 2 virtual-link 10.10.10.1 transmit-delay 5
WEC8500/configure/router/ospf 2#
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <Network> <OSPF> <Area> <Virtual-Link> menu in the sub-
menus.
The default window is shown below.
Unlike other configurations, there are two tabs at the top; General page and
Authentication page.
Start configuration in the General page for the basic configuration of Virtual-Link.
In the default configuration page, configure PROCESS ID, AREA ID, or LINK ID.
For detail configuration, select a PROCESS ID you want. Operator can do detail
configuration for an item you select.
The detail configuration page is shown below.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Seconds (default: 5)
Seconds
81