Syslog Configuration
The system log (syslog) configuration is required to transmit an event, alarm, and system
log information to a target syslog server. You can configure maximum two target syslog
servers in the system and you can configure the IP address and port number
independently. In addition, because you can configure a filter level, only filtered log
information is transmitted to the syslog server.
Configuration using CLI
To transmit an alarm, event, and system log to the syslog server, executes the command
as follows:
1
WEC8500# configure terminal
2
WEC8500/configure# syslog enable
3
WEC8500/configure# syslog add 192.168.0.91
WEC8500/configure# syslog add 192.168.0.99 udpport 510
4
WEC8500/configure# syslog level information
5
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Administrator> and then select the
<Logs> <SysLog Configuration> menu in the sub-menus.
It provides syslog related configuration and retrieving function.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
To transmit an alarm, event, and system log information to the syslog
server, specify 'enable' as a parameter.
Configure the IP address and UDP port of a target syslog server (the
default of the UDP port is '514'.).
Configure a log level to filter.
To check the configured syslog information, use the 'show syslog conf'
command.
468