Samsung WEC8500 Operation Manual page 160

MODE
LOCATION
MODE
STATE
REDUNDANCY
5
Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Configuration>, select <AP Groups>
in the submenu, and then select an AP group to configure. In the 'General' tab of the AP
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Parameter
OVERWRITE-AP-
the group is applied to all APs within the group.
AP-MODE
available:
• generalAp: General operation mode. Default value.
• rootAp: AP mode where a repeater AP can be connected.
• repeasterAp: AP mode that is connected to a wireless area and
OVERWRITE-
the group is applied to all APs within the group.
LOCATION
OVERWRITE-IP-
group is applied to all APs within the group.
IP-MODE
following modes are available:
• dhcp: The AP receives IP address allocation using DHCP.
• ap: The AP uses a manually configured IP address.
OVERWRITE-
group is applied to all APs within the group.
shutdown
OVERWRITE-
(primary-apc, secondary-apc, tertiary-apc) of the AP group is
applied to all APs within the group.
DISCOVERY
method used for APs to connect to the APC. The following modes
are available:
• ap-followed: The discovery type and discovery list configured
• apc-referral: The APC list configured for the APC is used as the
• DHCP: The APC list information relayed by DHCP option 138
• auto: Discovery type is automatically changed by the AP for
PRIMARY-APC
connect to this APC first.
SECONDARY-APC
to connect to the primary APC, the AP attempts to connect to this
APC on its second connection attempt.
TERTIARY-APC
to connect to the secondary APC, the AP attempts to connect to
this APC on its third connection attempt. The WEC8050 model
does not support Tertiary-APC.
Use the 'show ap-group detail [AP_GROUP_NAME]' command to check
the AP group information.
Description
If overwrite-ap-mode is enabled, the AP mode information set for
This is the AP operation mode. The following modes are
the APC through the root AP.
If overwrite-location is enabled, the location information set for
This is the location information of the AP.
If overwrite-ip is enabled, the IP mode information set for the
This is the mode of receiving an IP address by the AP. The
If overwrite-state is enabled, the AP state information set for the
This sets the AP state to UP or DOWN.
If overwrite-redundancy is enabled, the redundancy setting
If the APCs are configured for redundancy, this configures the
for the AP are used.
discovery list.
(IPv4) or option 52 (IPv6) is used as the discovery list.
automatic connection to the APC.
This is the name of the primary APC server. The AP attempts to
This is the name of the secondary APC server. If the AP is unable
This is the name of the tertiary APC server. If the AP is unable
141