Qos; Acl Configuration - Samsung WEC8500 Operation Manual

QoS

The Access Control List (ACL) allows or blocks a specific network traffic based on an
operator's configuration. The APC provides QoS using ACL.

ACL Configuration

Access List Configuration
You can create or delete an access list for ACL configuration. To delete an access list,
an operator can enter the name of an access list directly or enter a command by copying
a value retrieved from the 'show running-config network'. But, if the access list is being
used in the WLAN ACL or Admin ACL, and so on, you cannot delete it. Therefore, check
if it is being used in the WLAN ACL or Admin ACL first of all.
Configuration using CLI
1
APC# configure terminal
APC/configure# fqm-mode
2
APC# configure terminal
APC/configure# fqm-mode
APC/configure# access-list ip acl1 permit seq 1 icmp any any
APC# configure terminal
APC/configure# fqm-mode
APC/configure# no access-list ip acl1 permit seq 1 icmp any any
3
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Security>  <Access Control Lists>  <IP ACL> menu in the sub-menus.
The initial window of ACL rule configuration is shown below. When you click the <Add>
or <Delete> button, you can add or delete ACL rule.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to fqm mode where you can configure the configure  rule of CLI.
Create an access list by entering the 'access-list' command. The 'no'
parameter is used to delete an access list.
o access-list [ip/ipv6/mac] [ACL_NAME] [deny/permit/time-profile] seq
[seq_NUM]
[1/*/ahp/eigrp/esp/gre/icmp/igmp/igrp/ip/nos/ospf/pcp/pim/17/6/tcp/u
dp/1-255] [any/A.B.C.D A.B.C.D/URL] eq [eq_VALUE] [any/A.B.C.D
A.B.C.D/URL] eq [eq_VALUE] os-aware [os-aware_VALUE] [[[dscp
[*|[0-63]]|precedence [*|[0-7])]]]|]
An example of entering a command is shown below.
o Creating Access list 'acl1':
o Deleting Access list 'acl1':
Check a created access list using the 'show running-config network'
command.
96