Samsung WEC8500 Operation Manual page 106

Among the interface items displayed on the screen, configure the interface that a user
wants.
Interface General Configuration
Configuration using CLI
Unlike other OSPF configurations, the interface general does not enter into the OSPF
mode. Perform related configuration at the interface that a user wants. Therefore, the CLI
configuration is as follows:
1
WEC8500# configure terminal
WEC8500/configure#
WEC8500/configure# interface ge2
2
WEC8500/configure/interface ge2# ip ospf ?
address
authentication
authentication-key
cost
database-filter
dead-interval
disable
hello-interval
message-digest-key
mtu
mtu-ignore
network
priority
retransmit-interval
advertisements
transmit-delay
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure  interface configuration mode of CLI.
The items for detail configuration are as follows:
Address of interface
Enable authentication
Authentication password (key)
Interface cost
Filter OSPF LSA during synchronization and flooding
Interval after which a neighbor is declared dead
Disable OSPF
Time between HELLO packets
Message digest authentication password (key)
OSPF interface MTU
Time between HELLO packets
Network type
Router priority
Time between retransmitting lost link state
Link state transmit delay
DISABLE OSPF configuration
87