Ap Connection Management; Apc Management; Managing Apc List; Chapter 4 Ap Connection Management - Samsung WEC8500 Operation Manual

Chapter 4
This chapter describes the various configuration methods to manage the connection
between the APC and AP.

APC Management

Managing APC List

To enable the APC system to provide the cluster or redundancy service, several APC
systems must be installed at a site and each APC must have the information of other APC
systems.
Therefore, the APC system provides the function of managing the list of APCs that will
provide the cluster or redundancy function. And the APCs added to the APC list are used
during cluster or redundancy configuration.
One APC system that will be saved in the APC list consists of an APC name and Medium
Access Control (MAC) information. For the MAC address of another APC system, enter
the MAC address retrieved from the Monitor  Summary  Inventory  MAC Address
menu of system WEC screen.
By default, its own system information is added to the APC list. For the APC, operator
can only change its name, but cannot delete it forcibly or change its MAC address.
The maximum number of APC systems that can be registered per model is as follows:
Configuration using CLI
The procedures for configuration are as follows:
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc/apc-list#
WEC8500/configure# apc
WEC8500/configure/apc/apc-list#
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
AP Connection
Management
APC Model
WEC8500
WEC8050
1
Go to the configure mode of the CLI.
2
Go to the apc-list item of CLI.
3 Add, delete or change APC.
o add-apc [APC_NAME] [MAC_ADDRESS]
o del-apc [APC_NAME]
The maximum number of APC systems that can be registered
12
2
127