Figure 197. Configuring 802.11H; H Configuration - Samsung WEC8500 Operation Manual

802.11h Configuration

The APC supports the configuration and transmission power limitation for the Dynamic
Frequency Selection (DFS) function in an AP. When the AP detects radar, an event is sent
to the WEM and a detouring channel can be configured in the AP.
Configuration using CLI
For channel switching announcement related configuration and power constraint value
configuration in an AP, execute the command as follows:
1
APC# configure terminal
APC/configure# 80211h
APC/configure/80211h#
2
3
4
Configuration using Web UI
In the menu bar of <WEC Main window>, select <CONFIGURATION> and then select
the <RADIO>  <802.11a/n>  <802.11h> menu in the sub-menus.
Figure 197. Configuring 802.11h
•
•
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure  80211h configuration mode of CLI.
Configure the 802.11h information.
o channel-switch [MODE] [RESTRICTION] [SWITCH COUNT]
Parameter
MODE
RESTRICTION
SWITCH COUNT
Configure the transmission power of a wireless terminal.
o power-constraint [VALUE]
Parameter
VALUE
To check the configuration information, use the 'show 80211h
configuration' command.
POWER CONSTRAINT: Power constraint value (0-100)
CHANNEL SWITCH: Enables channel switch announcement.
Description
Whether the switching
enabled/disabled
Whether the channel packet transmission restriction mode is
enabled (disable/enable)
Waiting time until channel switching announcement
Description
Transmission power (0-31 dB)
announcement function is
275