Figure 60. Acl Configuration Window; Figure 61. Window Where A Time Profile Is Applied To Acl - Samsung WEC8500 Operation Manual

Figure 60. ACL Configuration Window
To change the configuration of ACL rule, click ACL NAME to change. You can change
the configuration using the <Add> or <Delete> button. In addition, if there is a time profile
in an ACL name, the IP ALC window is changed as shown below. After selecting a time
profile, click the <Apply> button to apply the time profile to the ACL.
Figure 61. Window where a Time Profile is Applied to ACL
ACL Rule Configuration
Configuration using CLI
1
APC# configure terminal
APC/configure# interface [name]
APC/configure/interface [name]#
2
APC# configure terminal
APC/configure# interface ge2
APC/configure/interface ge2#ip access-group fqm in acl1
3
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to interface configuration mode where you will apply the configure 
ACL rule of CLI.
Configure ACL to an interface.
o ip access-group [MODE] [DIRECTION] [ACL_NAME]
Parameter
MODE
DIRECTION
ACL_NAME
An example of entering a command that configures 'acl1' to the 'ge2'
interface is shown below.
To check the configuration information, use the 'show running-config
network' command.
Description
Configuration mode (fw/fqm)
Application direction configuration (in/out)
ACL name to configure
97