Figure 5. Management Port Configuration; Wec8500/Wec8050 (Apc) Operation Manual V10.1 - Samsung WEC8500 Operation Manual

LED
Console Port (RS232C)
A console port is used to check the operational status of WEC8500 or for input through
the CLI. Its basic requirements are as follows:
•
•
•
•
•
Management Port (1 GE UTP)
The WEC8500 provides a 10/100/1000BASE-T port (RJ-45) for management purpose.
It is working in 10/100 Mbps half duplex/full duplex mode or in 1000 Mbps full duplex
mode. Because it supports the automatic MDI/MDI-X function, you can use a straight-
through cable for all the network connections to a PC, server, switch, or network hub.
Figure 5. Management Port Configuration
Configuration item
LED
Connector
When connecting a cable to the management port, make sure to check if the cable
complies with the 10 BASE-T, 100 BASE-TX, or 1000 BASE-T.
•
•
•

WEC8500/WEC8050 (APC) Operation Manual v10.1

©Samsung Electronics America
Status Description
Red Power is turned off or a fault occurred while the power module 2
is installed.
Off Power module 2 is not installed.
Baud rate: 115200 bps
Character size: 8 characters
Parity: None
Stop bit: 1, Data bit: 8
Flow control: None
Status Description
Green Turned on for link connection
Orange Blinking for data exchange
- Connector for UTP cable connection
Cable type: UTP or STP cable using RJ-45 connector
o 10 BASE-T: Category 3 or higher
o 100 BASE-TX: Category 5 or higher
o 1000 BASE-T: Category 5 or higher (Category 5e or higher is
recommended)
Isolate from wireless frequency disturbing waves
Shut down electrical surge
LED
Connector
6