Samsung WEC8500 Operation Manual page 447

is not configured.)
•
•
[Configuring based on IP address]
Enable or disable.
•
•
Configure the index of a server that a NTP client will refer to. (Use a default value 1 if it is
not configured.)
•
•
Configure the version of a server that a NTP client will refer to. (Use a default value 1 if it
is not configured.)
•
•
You can proceed with configurations simultaneously as shown below.
•
•
•
•
•
•
•
•
[NTP Server Configuration]
The NTP server configuration is as follows:
1
WEC8500# configure terminal
2
[Checking NTP Configuration Status]
To check the status of a NTP client or server, enter the 'show ntp' command.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
ntp client server-addr hostname <WORD> version [1-4]: Enable
no ntp client server-addr hostname <WORD> version [1-4]: Disable
ntp client server-addr ip <A.B.C.D>: Enable
no ntp client server-addr ip <A.B.C.D>: Disable
ntp client server-addr ip <A.B.C.D> index [1-5]: Enable
no ntp client server-addr ip <A.B.C.D> index [1-5]: Disable
ntp client server-addr ip <A.B.C.D> version [1-4]
no ntp client server-addr ip <A.B.C.D> version [1-4]
ntp client server-addr hostname <WORD> index [1-5] version [1-4]
ntp client server-addr hostname <WORD> version [1-4] index [1-5]
ntp client server-addr ip <A.B.C.D> index [1-5] version [1-4]
ntp client server-addr ip <A.B.C.D> version [1-4] index [1-5]
no ntp client server-addr hostname <WORD> index [1-5] version [1-4]
no ntp client server-addr hostname <WORD> version [1-4] index [1-5]
no ntp client server-addr ip <A.B.C.D> index [1-5] version [1-4]
no ntp client server-addr ip <A.B.C.D> version [1-4] index [1-5]
Go to the configure mode of the CLI.
Configure a NTP server.
o ntp server enable: Configures a NTP server.
o no ntp server enable: Disables a NTP server.
428